The business of manufacturing heat transfers for garments and fabrics was literally turned on it's head with the introduction of the first Audley DTF printer.   This revolutionary print technology pretty much eliminated most of the work and cost required to produce heat transfers with old style print & cut vinyl process.

The video below shows the whole process from start-to-finish.   Simply add a print ready logo to the software then set the quantity required and start printing.  The finished product is heat-press-ready logos with no further work required other than cutting the sheet into separate logos and then heat press onto the garment.

Note: This video was made using the first generation Audley DTF printer and adhesive application system.  The latest 2 head 60cm printer and shaker with many improvements can be seen below.

30cm, 2 head DTF Printer System Spec's

This compact DTF print system is no slouch.

• Dual Epson P600 print heads. (1 x CMYK & 1 x White)
• 35 cm print width (Actual print width limited by film width)
• European made SAI Flexi RIP software
• Print speed of 1.3 sq mtrs per hour in high quality 8 pass print mode
• Automatic white ink circulation and filtration system
• Heated vacuum bed to hold film down during printing
• Bottom heat for ink drying
• Heat plate at entry to adhesive powder applicator
• Automatic application of adhesive powder
• Beater  bar - removes powder from unprinted areas of film
• Top heat finishing to melt adhesive layer
• Auto rewind of printed film
• Vacuum air filtration system

60cm, 2 head DTF Printer System Spec's

• Dual Epson i3200 print heads. (1 x CMYK & 1 x White)
• 70 cm print width (Actual print width limited by film)
• European made SAI Flexi RIP software
• Automatic white ink circulation and filtration system
• Heated vacuum bed to hold film down during printing
• Heated printer beds
• Top heat for accelerated ink drying
• Heat plate at entry to adhesive powder applicator
• Automatic application of adhesive powder
• Beater  bar - removes powder from unprinted areas of film
• Top heat finishing to cure ink and melt adhesive powder
• Auto rewind of printed film
• Vacuum air filtration system

60cm, 4 head DTF Printer System Spec's

• 4 x Epson i3200 print heads. (1 x CMYK & 1 x White)
• 70 cm print width (Actual print width limited by film)
• European made SAI Flexi RIP software
• Print speed of 8 sq mtrs per hour in high quality 8 pass print mode
• Automatic white ink circulation and filtration system
• Heated vacuum bed to hold film down during printing
• Bottom heat for ink drying
• Top heat for accelerated ink drying
• Heat plate at entry to adhesive powder applicator
• Automatic application of adhesive powder
• Beater  bar - removes powder from unprinted areas of film
• Heat finishing tunnel to cure ink and melt adhesive layer
• Auto rewind of printed film
• Vacuum air filtration system